Fourth press of the JET pad turns pump back to low-speed.Most Balboa hot tub control systems have three operating modes: Standard, Economy and Sleep. Third press of the JET pad turns jets off for all-quiet mode. Second press of the JET pad activates pump on high-speed. First press of the JET pad activates pump on low-speed (and starts soak timer). Use the JET pad on the bather panel or auxiliary jet control panel.Once you have done this, pull it out of the wall and disconnect the control panel connector from your power board. The panel will be stuck to the wall of the hot tub by a powerful sealant, so you will need to be quite energetic to get the panel off at all. This is usually done by prying it off, either with a craft knife or a crow bar.
Contact your service organization to arrange a service call.spa or through a hole in the side panel of the spa. If code 'M022' appears, there is an issue with the operation program. Step 3 - Add the New Hot Tub Control PanelThen check the LCD window on the control panel for a diagnostic code. Make note of the connector's position before you move on. Adobe fuse character creatorOnce you are satisfied, turn off the electricity and remove the control panel from the power board. If this works you should be able to program the buttons. Turn on the power to the system and check that your hot tub control panel lights up. Used In 2005-This Topside Replaced Part Number 650-0582 And Was Used In Models: Epic, Reward, And Destiny.Plug your new panel into the board without fitting it. A concrete pad is the best example of a solid, flat surface, however, wood deckingMarquis Spa 10 Button Topside Control Panel. This is to ensure that the spa cabinet is not exposed to a pressure stress condition that may result in cabinet damage and shell cracking. Runasdate for windows 10Put it into place and screw the panel onto the tub wall. Step 4 - Connect Your PanelUse an old coat hanger to pull the connector down the tubes toward the power board. Press it into the hole and ensure the sealant goes all the way around. Put your silicone sealant on the back of the hot tub control panel and push it into position. Using a spatula or the edge of your crow bar, clean off the old sealant.
0 Comments
Leave a Reply. |
AuthorKenneth ArchivesCategories |